علوم و مهندسی آبیاری

علوم و مهندسی آبیاری

شبیه سازی اثر دما بر جریان خروجی از قطره چکان ها

نویسندگان
1 دانشجویان دکتری آبیاری و زهکشی، دانشکده مهندسی علوم آب دانشگاه شهید چمران اهواز
2 استاد گروه آبیاری و زهکشی دانشکده مهندسی علوم آب دانشگاه شهید چمران اهواز
3 دانشجوی دکتری آبیاری و زهکشی، دانشکده مهندسی علوم آب دانشگاه شهید چمران اهواز
چکیده
قطره چکان ها که مهمترین قسمت آبیاری قطره ای محسوب می شوند، به منظور خروج آهسته و یکنواخت آب طراحی شده اند . یکنواختی خروج آب از قطره چکان ها به عوامل متعددی از جمله دمای آب وابسته است . تغییرات دمایی روی خصوصیات آب، مخصوصاً لزجت آن تأثیر می گذارد که می تواند یک عامل تأثیر گذار بر دبی خروجی از قطره چکان ها باشد . مطالعه صحرایی و آزمایشگاهی بر روی این موضوع هزینه بر و وقت گیر می باشد . دینامیک یک ابزار مفید برای مطالعه رفتار جریان در مجاری آب به شمار می رود. لذا در این تحقیق تأثیر دما بر دبی سه نمونه از یک (CFD) سیالات محاسباتی 45 و ،35 ،25 ،20 ،15 ، 16 متر ارتفاع آب و هر فشار در شش دمای 5 / 12 و 33 /25 ،9/2 ،6/1 ،4 ، نوع قطره چکان تیپ پلاک دار تحت شش فشار 2 ،(SEM) شبیه سازی گردید . بدین منظور، پس از تعیین اندازه مجاری قطره چکانها توسط میکروسکوپ الکترونی CFD 55 درجه سانتی گراد توسط محاسبه شد . صحت سنجی نتایج نشان داد که نتایج حاصله از شبیه سازی مطابقت خوبی با نتاج آزمایشگاهی دارد . مقدار CFD دبی آن ها توسط
متوسط خطای پیش بینی دبی برای مدل آرام حدود 4 درصد و برای مدل آشفته حدود 9 درصد می باشد و همچنین مشخص گردید دبی قطره چکان های مورد مطالعه نسبت به تغییرات دمایی حساس نمی باشد و دینامیک سیالات محاسباتی می تواند ابزار بسیار مناسبی برای کاهش هزینه و زمان مطالعه خصوصیات هیدرولیکی قطره چکان های با مجاری مارپیچ باشد.
کلیدواژه‌ها

عنوان مقاله English

Simulation of Temperature Effect on Emitter Discharge

نویسندگان English

Mehdi Delghandi 1
Saeid Broomand Nasab 2
Majid Behzad 2
Masoomeh Ferasati 3
1 Ph.D. Student, Department of irrigation & Drainage. Shahid Chamran Univ. Ahwaz, Iran
2 Professor, Water Sciences Engineering Faculty, Shahid Chamran Univ. Ahwaz, Iran
3 Ph.D Student, Department of irrigation & Drainage. Shahid Chamran Univ. Ahwaz, Iran
چکیده English

Emitter is the key component in drip irrigation system; it is designed to let out the water in pipe to drop into the soil slowly and uniformly. Uniformity of emitter discharge is dependent on some parameters such as water temperature. Temperature variations influence water properties, especially viscosity. This may be a significant factor affecting flow through emitters. Field and laboratory study on this object is time-consuming and expensive. Computational fluid dynamics provides a promising tool to help in study of flow behavior of water passing through the channel of labyrinth. In this study, the flow in labyrinth channels was simulated by using the method of Computational Fluid Dynamics (CFD) to calculate temperature effect on emitter discharge for three sample of one type emitter. For this purpose, emitter discharge for the six pressures: 2, 4, 6.1, 9.2, 12.25 and 16.33 mH2O and six temperature: 5, 15, 20, 25, 35, 45 and 55 °C was simulated. Samples were destroyed and longitudinal and latitudinal cuttings for the samples were obtained and sizes of the channels were calculated by photography with Scanning Electronic Microscope (SEM). To simulate pressures and temperature effect on rate of discharge using CFD, laminar flow model and turbulence model was applied. Verification of Results showed that the simulated data had a good agreement with the experimental data and also emitter discharge is insensitive to temperature variations and CFD provides a promising tool to reduce the cost and time of study on emitters.

کلیدواژه‌ها English

Emitter discharge
Computational Fluid Dynamics (CFD)
Temperature
Ssimulation

  • تاریخ دریافت 15 تیر 1389
  • تاریخ بازنگری 12 اردیبهشت 1390
  • تاریخ پذیرش 14 اردیبهشت 1390
  • تاریخ انتشار 01 خرداد 1390